Yarn weights explained, from lace to jumbo
What the numbered yarn weight categories mean, how common names like DK and worsted map onto them, and why you should still swatch.
Turn a cross stitch pattern's stitch count into a finished design size and a fabric cut size with margin, on Aida, evenweave, or linen.
Updated 2026-11-22
Extra fabric for framing or finishing, usually 2 to 4 inches.
The cut size adds your margin on all four sides. Round up to the next inch when buying or cutting fabric.
Enter the stitch count of your cross stitch pattern and the count of your fabric, and the calculator gives you two numbers: the finished design size and the piece of fabric to cut once a margin is added on each side. It works in inches and shows the centimetre equivalents, which is handy when a chart gives stitches and a shop lists fabric in cm.
For evenweave or linen worked over two threads, use the over-2 preset or enter half the thread count as a custom count.
The design size is the stitch count divided by the fabric count:
Design size = stitches / fabric count
A 150-stitch wide pattern on 14-count fabric is 150 / 14, about 10.7 inches wide. The cut size adds the margin on both sides:
Cut size = design size + 2 x margin
With a 3 inch margin, that design needs fabric about 16.7 inches wide, so you would cut a piece at least 17 inches across.
Fabric counts are nominal and vary slightly between brands and dye lots, so treat the result as close but not exact. If the design will be stretched or laced onto a board, a little extra margin is safer than too little. For embroidery on ordinary fabric, transfer the design rather than counting threads, and this calculator does not apply.
What the numbered yarn weight categories mean, how common names like DK and worsted map onto them, and why you should still swatch.